WS AutoVoice M2

Made using the most modern technology, automatic call handling equipment that fully meets today’s needs, as a supplement to PBX systems.
Even with a higher level of knowledge than the center’s own operator.

- Management of 2 analog telephone lines.
- 1 programming phone input.
- RJ11 telephone connections.
- Built-in message memory 2x4Mb (2x8Mb, 2x16Mb).
- Built-in battery clock.
- Caller side busy tone monitoring.
- Additional side busy tone monitoring.
- Fax tone monitoring (CNG).
- Create up to 12 different outgoing messages.
- 4 programmable time zones.
- 3 system modes (dialer, information only, reception of incoming calls prohibited).
- 6 programmable dialing modes
- Normal numeric dialing.
- 1-button speed dial.
- Selection according to the specified number sequence.
- Selection from a table according to a given number sequence.
- Switch operator to any button.
- Selection disabled, always operator switching.
- Programmable caller and extension side busy sound detection.
- Adjustable selection digit length.
- Programmable flash time and ring number.
- Programmable operator and fax extension (maximum 10 digits).
- Phone number table: 10 x 10 digits.
- Digit definition table: 20 x 5 digits.
- Outgoing message recording from a telephone or external audio source.
- Programming mode with PIN code.
- LED status indication.
- DTMF dialing.
- Supply voltage: 12VDC.
- Operating temperature: 0°C – 40°C.
- Operating humidity: maximum 80%.
- Size: 130mm x 75mm x 30mm.