- Transformer sharing: one transformer supplies several modules that have this service.
- Access with a card and/or central access code on the DGP-R915 reader.
- Arming with a card and PIN code on the DGP-R915 reader.
- Connection for 1 door (card reader, REX (exit request device), opening sensors and lock).
- Only run 4 wires between the reader and the DGP-ACM12 if you are using a DGP-R910 or DGPR915 reader.
- Field upgradeable firmware using CONV4USB and WinLoad.
- Automatic opening schedule.
- Door left open and Door forced open alarms.
- Door opening and extended delay timing.
- Door that can be opened manually with a button or PGM event.
- Door opening Fire alarm option.
- Security mode option (during a loss of communication, the access control door connected to the module can grant entry permission to 4 specific or any number of valid cards).
- Built-in, supervised 1A switching power supply.
- The AUX output can be activated or deactivated with a push button.
- It supports 4-wire and 26-bit Wiegand card readers.
- Center compatibility: Any DGP-848 center with access control function and any DGP-NE96, EVO center.
- Number of inputs: 2 (Negative trigger and tamper inputs).
- Number of outputs: 2;
- Number of zones: 2 (opening sensor and REX).
- Battery: 12VDC, 4Ah minimum.
- Can be installed in a 20cm x 25.5cm x 7.6cm metal box.
- Supply voltage (primary): 16VAC.
- Power supply (secondary-AUX): 12VDC.
- Power requirement: 20/40VA, 50 - 60Hz.
- Current consumption: 600mA.